CDA INDUCTION HOB HVN61/81 User Manual
Page 12
How to install the hob:
Overall dimensions of the hob:
HVN61FR: Width: 580 mm Depth: 510 mm
HVN81FR: Width: 770 mm Depth: 510 mm
Worktop cut-out dimensions:
HVN61FR: Width: 560 mm Depth: 490 mm
HVN81FR: Width: 750 mm Depth: 490 mm
1. Make the required hole in the worktop. Before doing this, you must check the instructions supplied with any cooker
hood to ensure that you will have the required clearance. The cut-out (Fig.6) shows a 60mm gap from the wall to
the cut-out edge. The distance from the hob, when fitted, to the back wall is 50mm.
If a splashback/worktop upstand is to be fitted, take this into account when cutting the hole. The minimum distance
that the hob should be positioned away from the rear wall or splashback is 50mm.
2. Fix the foam seal underneath the appliance by following the outline of the worktop upon which the hob will rest
This ensures an airtight seal with the worktop. Do not use silicone type sealant.
Fig.4
Fig.5
400mm
600mm
Fig.6
40
40
60
40
A
ventilation
space
510
580/770
490
560 / 750
64
min 4mm
Above an oven