Important safety instructions, Warnings, Cautions – Cecilware GB5MV-10-LD User Manual
Page 4
IMPORTANT! Read the following important safety instructions to avoid personal injury or
death, and to avoid damage to the equipment or property.
IMPORTANT SAFETY INSTRUCTIONS
WARNINGS
The GB8MP-10-LD-U (only) is equipped with two (2) power switches and two (2) 120 volt grounded
power cords. To avoid any injury, turn both power switches OFF. Or, unplug both power cords and allow
unit to cool completely before performing any maintenance or cleaning.
The GB5MV-10-LD and GB6MP-10-LD-U are equipped with one (1) power switch and one (1) 120
volt grounded power cord.
Plug units into properly grounded electrical outlets of the correct voltage, size, and plug configuration.
The GB8MP-10-LD-U (only) requires two (2) separate dedicated outlets.
If the plug and receptacle do not match, contact a qualified electrician to determine the proper voltage and
size and install the proper electrical outlets.
These units have no “user” serviceable parts. To avoid damage to the unit or injury to personnel, use
only Authorized Cecilware Service Agents and Genuine Cecilware Parts when service is required.
Genuine Cecilware Replacement Parts are specified to operate safely in the environment in which they
are used. Some aftermarket or generic replacement parts do not have the characteristics that will allow
them to operate safely in Cecilware equipment. It is essential to use Cecilware Replacement Parts when
repairing Cecilware equipment. Failure to use Cecilware Replacement Parts may subject operators of the
equipment to hazardous electrical voltage, resulting in electrical shock or burn.
CAUTIONS
Place the unit at the proper counter height in an area that is convenient for use. The location should be
level to prevent the unit or its contents from accidentally falling, and strong enough to support the weight
of the unit and its contents.
To avoid any injury or damage to the unit do not move or relocate the unit for cleaning.
Abrasive cleaners could scratch the finish of your unit. Use only mild, non abrasive cleaners.