Valet, Mode, Panic mode – CLIFFORD 330X1 User Manual

Page 10

Valet

mode

You can prevent your system from arming, by using Valet

Mode. This

is very useful when washing the vehicle or having it serviced. In Valet

Mode, the system will not arm, even with the transmitter, but all con-

venience functions (door locks, boot release, etc.) will work normally.

To enter or exit Valet® Mode with the Valet® switch:

Turn the ignition to ON position, and then turn it to the OFF

position.

Press and release the Valet

button within 10 seconds.

The status LED will light steady if you have entered Valet

Mode.

To exit Valet

Mode, repeat the steps above. The LED will turn

off when exiting Valet

Mode.

Panic mode

(If programmed On, above steps 3-4 )

If you are threatened in or near your vehicle, you can attract attention

by triggering the system with your transmitter! If your factory keyless

transmitter does not have a panic button, this system can be pro-

grammed to enable a panic feature.

G330X_1-3_2008_02B.qxd 2/14/2008 4:28 PM Page 7