Dell Precision 350 - Manual (Page 22)

22 S e t u p a n d Q u i c k Re f e r e n c e G u i d e
www
.dell.com | support.dell.com
1 Open the Dell Diagnostics on your hard drive or from the Drivers and
Utilities CD.
From your hard drive:
a Shut down and restart the computer.
b When F2 = Setup appears in the upper-right corner of the
screen, press .
If you wait too long and the Microsoft
®
Windows
®
logo appears,
continue to wait until you see the Windows desktop. Then shut
down your computer and try again. After the computer boots to
the Dell Diagnostics, go to step 2.
From the Drivers and Utilities CD:
a Shut down and restart the computer.
b When F2 = Setup appears in the upper-right corner of the
screen, press .
If you wait too long and the Microsoft Windows logo appears,
continue to wait until you see the Windows desktop. Then shut
down your computer and try again.
NOTE: This feature
changes the boot sequence
for one time only. On the
next start-up, the
computer boots according
to the devices specified in
system setup.
The Boot Device Menu appears.
c Change the Boot Sequence to use the IDE CD-ROM device as
the first device in the boot sequence.
d Insert the Drivers and Utilities CD into the CD drive.
e Press to exit system setup and save your changes.
f Restart your computer.
The Dell Diagnostics Menu appears.
g Select Dell 32-bit Diagnostics from the numbered list. If
multiple versions are listed, select the version appropriate for your
computer.
2 When the Dell Diagnostics main menu appears, select the type of test
you want to perform.