CLIFFORD IntelliPage System Car Alarm - Manual (Page 38)

User-selectable features
Your IntelliPage allows you to set many of its features to your own personal
preferences. Although the system’s programming capabilities are very extensive, we
have made the programming procedures very simple: to make a change, you just flick
the PlainView switch a few times. Once you’ve changed a few settings, you’ll find that
programming IntelliPage is so easy that you can even do it while driving! The system
comes with all of its features pre-programmed as noted by the bold type in the Table of
user-selectable features on pages 38-39. To change any of the settings, use the steps
noted below. To restore the feature to its factory setting, just repeat the procedure or use
the Reset all features option (see page 37):
How to change a user-selectable feature:
Briefly, here’s how it will work:
•
You will pick a feature from the Table on pages 38-39, noting the feature’s
column and row numbers.
•
First you’ll need to get into program mode by entering your valet code (see pages
18-19). After you have entered your valet code, press and hold the momentary
side of the PlainView switch until you hear a chirp. You’re now in the “Feature
Select” position.
•
Next you’ll press the latched side of the switch a number of times identical to the
column number. Lastly, you will press the momentary side of the switch a number
of times corresponding to the row number.
That’s all there is to it! After you enter the feature’s column and row numbers, you’ll
pause for a second and hear either one chirp to indicate that the feature has been turned
off, or two chirps if turned on. It’s easy once you’ve done it. Try the examples on page
36 to get the hang of it.
Step-by-step programming instructions
1. Refer to the Table of user-selectable features and make note of the column (across)
number and the row (down) number of the feature(s) you wish to program.
2. Turn on the ignition, or start the engine (skip this step if the engine is running).
3. Enter your valet code (see pages 18-19), then press and hold the PlainView switch to
its momentary side for about 3 seconds until you hear a siren chirp (the system LED
will also turn on to indicate that the system is in programming mode.) You are now
in the “Feature Select” position at the top left of the table.
4. Select the feature column: Toggle the switch in and out of the latched position the
same number of times as the column number of the selected feature (NOTE: each
latched-to-center motion is counted as one). Pause. You will hear the same number
of chirps as the column number you have selected, audibly confirming your selection.
5. Select the feature row: Press and release the momentary side the same number of
times as the feature’s row number. You’ll will hear a chirp each time you press.
6. If there is a NOTE for the selected feature, perform the actions noted.
7. Pause. You will hear either one or two chirps: Two chirps = ON, one chirp = OFF.
8. You may select another feature, or you may exit program mode:
35