CLIFFORD IntelliPage System Car Alarm - Manual (Page 23)

Setting your own secret valet code
Since all Clifford systems have the same factory-set valet code, it is highly advisable
that you set your own valet code. You may choose any 1-, 2-, or 3-digit code that does
not have any zeros. You can also change your valet code whenever you want. Simply
write down the 1-to-3 digit code you wish to use (remember, no zeros in the code), then
refer to the User-selectable features section on pages 35-39.
Example
Let’s say you want to set your valet code to 31. To do so, you would do the following:
1. From the Table of user-selectable features on pages 38 and 39, you would note that
the “set a new secret valet code” feature is in column 4, row 6.
2. Enter program mode by turning on the ignition, entering your current valet code, then
pressing the PlainView switch to its momentary side for 3 seconds until you hear a chirp.
3. Select column 4 by moving the switch between latched and center 4 times, i.e.:
latched, center, latched, center, latched, center, latched, center. After a brief pause,
you will hear 4 chirps to confirm that you have selected column 4.
4. Select row 6 by pressing and releasing the momentary side of the switch 6 times. To
help you count, you will hear a chirp each time you press the momentary side.
5. Immediately flip the switch to the latched position.
6. Enter you new code. To enter 31 as your new code, you would press the switch in this
manner: momentary, momentary, momentary, latched (you’ll hear 3 chirps to confirm
the first digit), momentary, latched (1 chirp to confirm the second digit), center.
7. Wait 3 seconds until you hear 2 chirps, indicating the new code has been accepted.
8. Turn off the ignition to exit program mode (you’ll hear a 3-chirp confirmation).
9. VERY IMPORTANT: You must immediately test your new secret valet code:
Turn on the ignition, enter your new code, then flip the switch to its latched position.
The LED will illuminate. If it does not, the new code you programmed and the one you
just entered do not match. In such a case, the system will revert to the previous code.
Remote controlled seat positioning
If your vehicle is equipped with power memory seats, the IntelliPage can automatically
adjust the driving position to your requirements before you even enter the vehicle. Just
remotely disarm and IntelliPage will automatically activate the vehicle’s factory
memory seat setting. What’s more, IntelliPage lets you define which remote control
activates which memory position. That means when you disarm with your remote, the
system will adjust the seating position to your settings. When your spouse disarms with
the other remote, the seating position will automatically adjust to your spouse’s settings.
In other words, when you disarm with remote #1, IntelliPage will automatically activate
the vehicle’s memory seat position #1; when disarmed with remote #2, memory position
#2 is activated, and so on in any combination you wish using up to four different remote
controls and four different memory positions.
The two remote controls that came with your IntelliPage have been preset to activate
your vehicle’s memory positions #1 and #2. You can change the assignments of these
two remote controls and/or associate additional remote controls with other memory
positions. See User-Selectable Features on pages 35-39.
20