Dell 1210S Projector - Manual (Page 46)

Guiding Signals
Projector
Status
Description
Control Buttons
Power
Indicator
TEMP
(Amber)
LAMP (Amber)
Standby mode Projector in Standby mode. Ready to power
on.
BLUE
Flashing
OFF OFF
Warming up
mode
Projector takes some time to warm up and
power on.
BLUE OFF OFF
Lamp on Projector in Normal mode, ready to display
an image.
Note: The OSD menu is not accessed.
BLUE OFF OFF
Cooling mode Projector is cooling to shutdown. BLUE OFF OFF
Power Saving
mode
Power Saving mode has been activated. The
projector will automatically enter standby
mode, if an input signal is not detected in
two hours.
AMBER
Flashing
OFF OFF
Cooling before
Power Saving
mode
The projector takes 60 seconds to cool down
before entering Power Saving mode. AMBER OFF OFF
Projector
overheated
Air vents might be blocked or ambient
temperature may be above 35ºC. The
projector automatically shuts down. Ensure
that the air vents are not blocked and that
the ambient temperature is within
operational range. If the problem persists,
contact Dell.
OFF AMBER OFF
Lamp driver
overheated
The lamp driver is overheated. The air vents
may be blocked. The projector automatically
shuts down. Turn the display on again after
the projector cools down. If the problem
persists, contact Dell.
AMBER AMBER OFF
Fan breakdown One of the fans has failed. The projector
automatically shuts down. If the problem
persists, contact Dell.
ÒFF
AMBER
Flashing
OFF
Lamp driver
breakdown
The lamp driver has failed. The projector
automatically shuts down. Unplug the power
cord after three minutes then turn the
display on again. If this problem persists,
contact Dell.
AMBER
Flashing
OFF
AMBER
Flashing
Color Wheel
breakdown
Color wheel cannot start. The projector has
failed and the projector automatically shuts
down. Unplug the power cord after three
minutes and then turn on the projector. If
this problem persists, contact Dell.
BLUE
AMBER
Flashing
AMBER
Flashing
Fault - DC
supply (+12V)
Power supply has been interrupted. The
projector automatically shuts down. Unplug
the power cord after three minutes and then
turn on the projector. If this problem
persists, contact Dell.
AMBER
Flashing
AMBER AMBER
Troubleshooting Your Projector 46