Disarming without a transmitter – CLIFFORD 12.5X User Manual

Page 28

disarming without a transmitter

This feature allows you to disarm the security system without the

remote transmitter should it be lost, damaged, or disabled. In order

to disarm the system without a remote transmitter, you must have

the vehicle’s ignition key and know where the Valet button is

located. Be sure to check with the installer for the location and the

number of presses of the Valet button required to disarm the system.

To disarm the security system,

turn the ignition to the ON posi-

tion. Press the Valet button the

preset number of times (one to

five times) within 15 seconds. After five seconds the system will

disarm. If the system does not disarm, you may have waited too long;

turn the ignition off and on and try again.

Location of Valet Button_________________________________

Number of Pulses______________________________________

The LCD remote will indicate disarm notification with 4 quick

beeps and 5 flashes of the

and triggered zone icons.

important! The unit can be programmed to respond to
one to five pulses of the Valet button for the disarm func-
tion. Be sure to check with the installer for the desired
programming.

DRW-35

➜