Dell OptiPlex XE (Early 2010) - Manual (Page 27)

Back to Contents Page
Hard Drive
Dell™ OptiPlex™ XE Service Manual— Small Form Factor
Removing the Hard Drive
1. Follow the procedures in Before Working Inside Your Computer .
2. Press in on the blue tabs located on either sides of the hard drive assembly, and lift the hard drive assembly out of the computer.
3. Disconnect the power and data cables from the hard drive.
4. Remove the hard drive assembly from the computer.
5. Pull up the blue tabs and remove the hard drive from the hard drive assembly.
Replacing the Hard Drive
To replace the hard drive, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.