Cub Cadet EX3200 User Manual
Cub Cadet Gardening equipment
This manual is related to the following products:
Table of contents
Document Outline
- INTRODUCTION
- 1. SAFETY PRECAUTIONS
- About This Manual
- Safety Alert Symbol
- Precautions Before Operating Your Tractor
- Safe Practices for Operating Your Tractor
- Operating Your Tractor on Slopes
- Traveling on a Road
- Safe Practices for Parking Your Tractor
- Operating the Power Take Off (PTO)
- Using the 3-Point Hitch
- Safety Frame (Roll-Over Protective Structure) (ROPS) Precautions
- Safe Practices for Servicing Your Tractor
- Understanding the Tractor Safety Decals
- 2. SERVICING THE TRACTOR
- 3. SPECIFICATIONS
- 4. IMPLEMENT CAPACITIES
- 5. NAMES AND FUNCTIONS OF COMPONENTS
- 6. PRE-OPERATION CHECK
- 7. OPERATING THE ENGINE
- 8. OPERATING THE TRACTOR
- 9. POWER TAKE OFF (PTO)
- 10. 3-POINT HITCH AND DRAWBAR
- 11. HYDRAULIC SYSTEM
- 12. TIRES, WHEELS AND BALLAST
- 13. MAINTENANCE
- 14. PERIODIC SERVICE
- n Warranty and Repair of the Engine
- Opening / Closing the Hood and Side Panels
- Daily Checks
- Checking the Engine Oil Level
- Inspecting the Transmission Oil Level
- Checking the Wheel Bolt Tightening Torque
- Checking and Adjusting the Brake
- Checking and Adjusting the Clutch
- Checking the Radiator Hoses and Clamps
- Checking the Tire Air Pressure
- Cleaning the Radiator Cooling Screen, Cooling Fins and Oil Cooler Pipe
- 1. Cleaning the Radiator Cooling Screen
- 2. Cleaning the Radiator Cooling Fins
- Cleaning the Grille and Side Screens
- Checking the Fuel line
- Checking the Power Steering line
- Checking the Seat Belt and Roll-Over Protective Structure (ROPS)
- Checking the Headlights, Hazard Lights, etc.
- Checking the Cooling System
- Refilling the Fuel Tank
- Inspection Procedure for Safety Interlock System
- 1. Range Shift Lever Neutral Switch
- 2. Mid-Power Take Off (PTO) Engagement Lever Switch (option)
- 3. Rear Power Take Off (PTO) Engagement Lever Switch
- 4. Seat Safety Switch
- 5. Checking the Operation of the Seat Safety Switch
- First 50 Hours
- Every 50 Hours
- Checking the Front Axle Oil Level
- Grease Specifications
- 1. Lubricating Grease Fittings on the Tractor
- 2. Lubricating the Hydraulic Implement Control Valve Linkage
- 3. Lubricating the Seat Slide Rails
- 4. Lubricating the 3-Point Hitch
- Servicing the Fan and Alternator Belt
- 1. Checking the Belt Tension
- 2. Adjusting the Belt Tension
- 3. Replacing the Belt
- Checking the Fuel / Water Separator
- Checking the Battery Condition
- Every 100 Hours
- Every 200 Hours
- Every 300 Hours
- Every 500 Hours
- Every 1000 Hours
- General Maintenance
- 15. SERVICING THE ELECTRICAL SYSTEM
- 16. STORAGE
- 17. TROUBLESHOOTING
- 18. INDEX