Advanced troubleshooting, Diagnostic lights – Dell XPS/Dimension XPS Gen 2 User Manual
Page 2
Back to Contents Page
Advanced Troubleshooting
Dell™ Dimension™ XPS Service Manual
Diagnostic Lights
To help you troubleshoot a problem, your computer has four lights labeled "A," "B," "C," and "D" on the back panel. The lights can be yellow or green. When
the computer starts normally, the lights flash. After the computer starts, all four lights display solid green. If the computer malfunctions, the color and
sequence of the lights identify the problem.
CAUTION:
Before you begin any of the procedures in this section, follow the safety instructions.
Light Pattern
Problem Description
Suggested Resolution
The computer is in a normal off condition
or a possible pre-BIOS failure has
occurred.
Verify that the computer is plugged into a working electrical outlet and that you have
pressed the power button.
A possible processor failure has occurred.
Reinstall the processor
and restart the computer.
Memory modules are detected, but a
memory failure has occurred.
1.
Reinstall all memory modules.
2.
Ensure that all the connector tabs are locked.
3.
Restart the computer.
4.
If the problem persists, contact Dell.
A possible expansion card failure has
occurred.
1.
Determine if a conflict exists by
removing a card
(not a video card) and then
restarting the computer.
2.
If the problem persists,
reinstall the card
that you removed, remove a different
card, and then restart the computer.
3.
Repeat this process for each card. If the computer starts normally, troubleshoot
the last card removed from the computer for resource conflicts (If the problem
persists, contact Dell).
A possible video card failure has occurred.
l
If the computer has a video card,
remove the card
, reinstall it, and then restart
the computer.
l
If the problem still exists,
install a video card
that you know works and restart
the computer.
l
If the problem persists or the computer has integrated video, contact Dell.
A possible floppy or hard drive failure has
occurred.
Reseat all power and data cables and restart the computer.
A possible USB failure has occurred.
Reinstall all USB devices, check cable connections, and then restart the computer.
No memory modules are detected.
1.
Reinstall all memory modules.
2.
Ensure that all the connector tabs are locked.