Crestron electronic QM-AMP3x80 Series - Manual (Page 28)

QuickMedia™ 3-Channel Amplifiers Crestron QM-AMP3x80 Series
Firmware Upgrade
A firmware upgrade file has the
extension .upg.
To take advantage of all the AMP3x80 features, it is important that the unit contains
the latest firmware available. Therefore, please check the Crestron website
(
http://www.crestron.com/downloads/software_updates.asp ) for the latest version of
firmware. Not every product has a firmware upgrade, but as Crestron improves
functions, adds new features, and extends the capabilities of its products, firmware
upgrades are posted. To upgrade the firmware, complete the following steps.
1. Make sure that “Communication Settings” that begins on page 20 has
been performed.
2. As shown after this step, select File Transfer | Load Network Device
from the Viewport menu.
File Transfer | Load Network Device Command
3. As shown after this step, select the Net ID of the AMP3x80 and then
click OK. The “Open” window appears (refer to the subsequent
graphic).
“Select Network ID” Window
NOTE: When transferring any Cresnet file (touchpanel project/firmware), lower the
port speed baud rate to 38400 to match the Cresnet bus speed.
24 • QuickMedia™ 3-Channel Amplifiers: QM-AMP3x80 Series Operations Guide – DOC. 6272