Canon CANOSCAN 9000F - Manual (Page 15)

Scanning Film
13
35 mm Slides
c
Align the Film Guide’s tab with the FILM
symbol on the platen glass of the scanner.
d
Place a slide or slides face down (correctly
viewed from below) in the Film Guide as
shown in the figure on the right.
120 Format Films
c
Align the Film Guide’s tab with the FILM
symbol on the platen glass of the scanner,
then open the Film Holder and remove the
Film Retainer Sheet.
d
Place the film face down.
e
Close the Film Holder.
• Leave a gap of 5 mm (0.2 in.) or greater
between films when placing two or more
120 format films on the platen glass.
• Ensure that there is no gap between the
edge of the film and the Film Guide on the
side near the Calibration Slot.
Calibration Slot
Calibration Slot