Dell Projector 3200MP - Manual (Page 30)

The screen does not display your presentation
If you are using a portable computer, press .
Image is unstable or flickering
Adjust the tracking in the OSD Computer Image tab.
Image has vertical flickering bar
Adjust the frequency in the OSD Computer Image tab.
Image color is not correct
If your graphic card output signal is "sync on Green", and you would like to display VGA at
60Hz signal, please go into "OSD--> Management --> Signal Type" and select "RGB".
Image is out of focus
Adjust the focus ring on the projector lens.
Ensure that the projection screen is within the required distance from the projector (4.0ft
[1.2m] to 39.4ft [12m]).
The image is stretched when displaying 16:9 DVD
The projector automatically detects 16:9 DVD and adjusts the aspect ratio to full screen with a 4:3 (letter-box) default
setting.
If the image is still stretched, adjust the aspect ratio as follows:
If you are playing a 16:9 DVD, select 4:3 aspect ratio type on your DVD player if capable.
If you cannot select 4:3 aspect ratio type on your DVD player, select 4:3 aspect ratio in the
"All Images" menu within the OSD function.
Image is reversed
Select Management from the OSD and adjust the projection mode.
Lamp is burned out or makes a popping sound
When the lamp reaches its end of life, it may burn out and may make a loud popping
sound. If this occurs, the projector will not turn back on until the lamp is replaced. To
replace the lamp, see "
Changing the Lamp ".
Remote mouse function does not work
Ensure the remote is aimed at the remote mouse receiver.
Replace batteries on remote if LED light does not operate when a remote button is pressed.
Ensure the USB remote mouse cable is properly inserted in the computer.
Power cycle the projector (power off projector->allow fans to run two minutes->unplug
projector->plug in projector->power on projector).
Back to Contents Page