Dell Vostro 230s (Early 2010) - Manual (Page 24)

Back to Contents Page
Power Button and Card Reader Light
Dell™ Vostro™ 230s Service Manual— Slim Tower
Removing the Power Button and Card Reader Light
1. Follow the procedures in Before Working Inside Your Computer .
2. Remove the cover .
3. Remove the front bezel .
4. Remove the chassis support bracket .
5. Remove the optical drive .
6. Press the plastic tabs inward to release the power button and card reader light cables from the chassis.
7. Unthread the power button and card reader light cables from their routing clip.
8. Disconnect the power button and card reader light cables from the system board and remove them from the computer.
Replacing the Power Button and Card Reader Light
To replace the power button and card reader light, perform the above steps in reverse order.
Back to Contents Page
WARNING: Before working inside your computer, read the safety information that shipped with your computer. For additional safety best
practices information, see the Regulatory Compliance Homepage at www.dell.com/regulatory_compliance.
NOTE: You may need to install Adobe® Flash® Player from Adobe.com in order to view the illustrations below.