Replacing the external modem connector – Dell Dimension 5100C User Manual
Page 88

88
Removing and Installing Parts
www
.dell.com | support.dell.com
3 Remove the existing modem:
a
Disconnect the modem cable from the modem.
b
Use a small Phillips screwdriver to remove the two screws securing the modem to the
system board, and set the screws aside.
c
Pull straight up on the attached pull-tab to lift the modem out of its connector on the
system board.
NOTICE:
The connectors are keyed to ensure correct insertion. If you feel resistance, check the
connectors and realign the card.
4 Install the new modem:
a
Align the modem with the screw holes and press the modem into the connector on the
system board.
b
Use a Phillips screwdriver to replace and tighten the two screws that secure the modem to
the system board.
c
Connect the modem cable to the modem.
5 Replace the computer cover (see page 91).
Replacing the External Modem Connector
1 Follow the procedures in "Before You Begin" on page 53.
2 Remove the computer cover (see page 59).
3 Remove the modem cable from the modem.
4 Remove the external modem connector:
a
Remove the screw that secures the external modem connector.
b
Slide the external modem connector away from the slot that holds the modem connector
in place.
c
Lift the modem cable and connector from the computer.