Installing the dishwasher, Dishwashers that can be integrated – Electrolux FAVORIT 44080 i User Manual

Page 30

Installation and connection instructions

1 Safety information for the installation

• Only transport the dishwasher in an upright position, otherwise salt water

may run out.

• Before using the dishwasher for the first time, check for any damage caused in

transport. Do not under any circumstances connect an appliance that is dam
aged. In the case of damage, please contact your supplier.

• Never use the dishwasher if the mains cable, water inlet or drain hose are

damaged; or if the control panel, work top or plinth area are damaged such
that the inside of the appliance is freely accessible.

• Always plug the mains plug into a correctly installed shockproof socket.
• Prior to using the appliance for the first time, ensure that the rated voltage

and type of supply on the rating plate match that of the supply where the ap
pliance is to be installed. The fuse rating is also to be found on the rating plate.

• Multi way plugs / connectors and extension cables must not be used. This

could constitute a fire hazard through overheating.

• The dishwasher’s cable must only be replaced by the Customer Care Depart

ment or a registered electrician.

• A water inlet hose with safety valve must only be replaced by the Customer

Care Department.

Installing the dishwasher

• The dishwasher must be installed on a firm floor and adjusted to ensure that it

is stable and level in all directions.

• To compensate for unevenness in the floor and to match the height of the appli

ance to that of surrounding units, extend the threaded feet using a screwdriver.

• Adjust the rear foot of the appliance using a cordless screwdriver from the

front of the appliance (see installation template).

• The drain hose, inlet hose and mains cable must be laid so that they are able to

move freely within the plinth area, and so that they are not kinked or crushed
when the dishwasher is in position.

• The dishwasher must also be screwed tightly to the work surface or to the ad

joining units. This is essential to ensure the dishwasher does not tip up.

Dishwashers that can be integrated

(see installation template supplied)
Using the installation template supplied split cupboard doors can be easily in
stalled and firmly fitted.