Electrolux FAVORIT 44080 i - Manual (Page 25)

25
What to do if…
What to do if…
Remedying small malfunctions
Before you call the Customer Care Department, please check whether
– you cannot remedy the fault yourself with the help of the following fault table
or
– whether it is caused by faulty, electrical connections and/or faulty water con
nections.
In these cases the engineer must make you liable for the costs of the Customer
Service intervention even during the warranty period.
If while the appliance is operating indicators on the control panel flash or are lit
up as described in the following table, please consult this to find out how to
remedy the fault.
After remedying the fault that is flashing in the first or second rhythm in the
programme progress display, press the button for the dishwashing cycle that
had already started. The cycle will continue.
In the case of other fault messages:
– Cancel the dishwashing cycle.
– Switch the appliance off and on again.
– Select dishwashing cycle.
If the fault is displayed again, please contact the Customer Care Department
and inform them of the fault message.
Malfunction Possible cause Remedy
The programme indicator for the
selected dishwashing cycle is
flashing,
the indicator for the end of the
dishwashing cycle is flashing in
rhythm 1 short light signal with
approx. 3 second pause in be
tween:
(Problems with water inlet)
The tap is blocked or furred
with lime scale.
Clean tap.
The tap is turned off. Turn the tap on.
The filter (where present) in the
threaded hose fitting on the tap
is blocked.
Clean the filter in the
threaded hose fitting.
Filters in the base of the wash
ing compartment are blocked.
Cancel the dishwashing cy
cle (see chapter: Starting a
dishwashing cycle),
clean filters (see chapter:
Cleaning the filters),
then start the dishwashing
cycle again.
Water inflow hose has not been
correctly positioned.
Check hose installation.