Cub Cadet 59A40003727 - Manual (Page 25)

25
probleM possible Cause soluTion
bucket or boom leaks
down from “Hold”
position • Leaks in hydraulic circuits
• Cylinder piston seals leaking
• Remote valve worn or damaged
• Tractor valve worn or damaged
• Tighten loose fittings. Use
thread sealer on pipe threads.
• Repair (if available) or replace.
• Repair.
• Repair.
Cannot lower boom • Hydraulic couplers not fully engaged. • Recouple hoses.
loss of bucket Tilt
Control when lever
is pushed Completely
forward • Tractor lever in “Float” position • Shift control lever from “Float”
position.
Couplers Hard
to Hook up • Pressure in circuit • Place control levers in “Float”
when connecting.
boom & bucket
operation does not
Correspond To Control
lever position • Improperly installed hydraulic couplers
• Hoses improperly connected
• Install hydraulic couplers
correctly.
• Connect hoses properly.
excessive wear on
bucket Cutting edge
and wear pads • Bucket is tilted too far forward and is riding
on cutting edge.
• Excessive down pressure when cleaning
feedlots and working on concrete.
• Keep bottom of bucket parallel
to ground.
• Use “Float” position on boom
lift control lever.