Campbell Hausfeld PW2002 - Manual (Page 4)

2. a. For model PW2002: Attach wire holders to handle and
frame as shown in figure 2 using a 3/8" or adjustable
wrench.
b. For model PW2102: Attach detergent tank to backside of
handle. Use the 4 hex bolts with flat washer under hex
head and 4 nuts provided.
3. a. Model PW2002: Slide clear plastic hose onto chemical
injector hose barb (Figure 4). Use other end for detergent
source.
b. Model PW2102: Slide clear plastic hose attached to leg
onto plastic hose barb of detergent tank (see Figure 5).
UNPACKING
Remove the equipment and all parts from the carton. The
carton should contain the following.
• One pressure washer (pump, engine, cart base)
• One cart handle assembly
• One detergent tank (PW2102) or gun/hose/lance wire
hangers (PW2002)
• One spray gun
• One lance with nozzle (additional lance included in
PW2102 model)
• One high pressure hose
• One pack of nuts, bolts, and
manuals
• One bottle of engine oil
If any parts are missing, DO NOT RETURN THE UNIT TO THE
RETAILER. Know the unit’s model number (located on the
serial number tag on the pressure washer frame) and call 1-
800-330-0712 for replacement parts.
After unpacking the product, inspect it carefully for any
damage that may have occurred during transit. Make sure to
tighten fittings and bolts before using the pressure washer.
Do not operate the unit if it’s damaged
during shipping, handling, or use.
Damage could result in bursting and cause injury or property
damage.
ASSEMBLY
Use two adjustable or 7/16” wrenches to assemble the
pressure washer.
1. Slide the handle assembly over the lower legs of the cart
base. Use the standard nut and bolt to secure the right
rear leg. See Figure 1.
!
WARNING
Pressure Washers
Pre-Operation
Figure 1 – Assemble Handle
Figure 4 - Pump hook up
Brass swivel adapter
Garden hose
Pump inlet
Pump
outlet
Chemical injector
hose barb
High
pressure
hose
Thermal
relief valve
Figure 2 – Assemble Wire Hanger
www.chpower.com
4
Figure 3 – Wire hanger on base plate