Carson SC-407 User Manual
Page 7
SC-407-10 Ver. B Installation and Operating Instructions Page 7 of 12
CP4842C 05/07/05
Light Control Rocker Switch Connections
The following diagram shows proper connection of the rocker switch leads located at the rear.
Note: Negative (NEG) connection must also be made on 10-Pin plug for rocker switches to light
up.
WARNING: The lighting control circuits of this unit are not fused. Automotive fuses or circuit
breakers must be connected between the power source and the unit properly rated for the circuit
requirements. Failure to install proper circuit breakers or fuses can result in damage to the unit
and/or vehicle.
GRN
Recommended
Wire Size
Amps
Size
5 - 10
#16
10 - 15
#14
15 - 30
#12
30 - 40
#10
40 - 50
#8
50 - 60
#6
Use next larger size
if longer than 10 ft.
GRN
BLU
Circuit Breakers
or Fuses
20 AMP Max.
LOAD A
LOAD B
LOAD C
+
BATT
-
A B C D
LOAD D
A
B
C
D
BLU
RE
D
YE
L
RED
YE
L
Switch
Leads
Hole
A
GRN/YEL Center
B
BLU/RED Center
C
GRN/YEL
Left
D
BLU/RED
Left
Switch Lead Sets