Califone POWERPRO PA916 - Manual (Page 13)

12
Passive Speaker System PA916-PS Operation
The PA916-SP is connected to one of two outputs from the PowerPro PA916 or Powered Companion Speaker via SP-50 Cable with
1/4” phone plugs.
Connecting to the “Speaker Out” jack will divide the power between the PowerPro PA916 or PA916-PS and PA916-SP. Connecting to
the “Switched Out” will disconnect the internal speakers of the PA916 and deliver all of the power to the PA916-SP.
NOTE: There are five (5) LEDs on the front of the speaker, however they are disconnected because there is no internal amplifier or
wireless receiver in this passive system.
Mechanical Notations
Telescoping Handle and Wheels
These are only intended for pulling the PowerPro over relatively smooth surfaces. Using the handle to lift or carry the unit or pull-
ing up stairs will cause damage not covered by the warranty.
Tripod Mount
A recess is incorporated on the bottom of all PowerPro Speakers for mounting to the TP-50 tripod.