Dell PowerEdge M610x - Manual (Page 9)

Processor Installation
9
b Open the grease applicator included with your processor kit and apply
all of the thermal grease in the applicator to the center of the topside
of the new processor.
c Place the heat sink on the processor. See Figure 1-1.
d Close the heat-sink release levers or replace the screws at the corners
of the heat sink. See your
Hardware Owner’s Manual for a system-
specific illustration. See Figure 1-1.
12 Replace the cooling shroud. See "Installing the Cooling Shroud" in the
Hardware Owner’s Manual.
13 Close the system. See "Closing the System" in the Hardware Owner’s
Manual.
14 Reconnect your system and peripherals to their electrical outlets, and turn
on the system.
15 Press to enter the System Setup program, and check that the processor
information matches the new system configuration. See "Entering the
System Setup Program" in the Hardware Owner’s Manual.
16 Run the system diagnostics to verify that the new processor operates
correctly.
17 See "Running the System Diagnostics" in the Hardware Owner’s Manual
for information about running the diagnostics.