Removing the switch from a din rail – Cisco 2955 User Manual
Page 6
6
Catalyst 2955 Switch DIN Rail Clip Installation Notes
OL-5262-01
Removing the Switch from a DIN Rail
Removing the Switch from a DIN Rail
To remove the switch from a DIN rail, follow these steps:
Step 1
Ensure that power is removed from the switch, and disconnect all cables and connectors from the front
panel of the switch.
Step 2
Push down on the top of the DIN rail clip release tab with your finger. As the clip releases, lift the bottom
of the switch, as shown in
.
Figure 5
Switch Removal in a Parallel Mounting Configuration
1
DIN rail clip
3
DIN rail clip release tab
2
DIN rail
104563
1
2
3