Carrier P/N 33CSHUMID-01 - Manual (Page 6)

Dehumidifying With Air Conditioning*
Page 5
Cool to Dehumidify: If Cool to Dehumidify is on
and the Humidity Module is installed, the thermo-
stat has the ability to initiate a cooling cycle for
advanced dehumidification operation. When the
thermostat detects the humidity percentage is
above the setpoint for dehumidification, and heating
or cooling is not on, the thermostat will force the
compressor to run with the fan, thus reducing
moisture in the air. The green LED will blink once
every eight seconds to indicate this is taking place.
This feature will also allow you to adjust the cooling
overshoot of the setpoint, from 0 to 5 .
For Example: If the cooling overshoot is set for 3 F and
the cooling setpoint is set for 74 F, then as long as the
room temperature reads between 71 F and 74 F this
feature will energize the compressor and fan to
dehumidify the air.
When the indoor humidity falls below the setpoint
you have selected, the Cool to Dehumidify function
will be de-energized. The value for this setpoint
ranges from 25% to 99%. For more information
regarding dehumidification using the air conditioner,
please consult your Owner’s Manual.
° °
°
°
° °
*Cool to Dehumidify may not be available with your thermostat
model number. Please consult your Owner’s Manual for details.