AAXA Technologies P4X - Manual (Page 32)

Technical Details
30
Chapter 4
IMAGE IS BLURRED
Possible Causes Solution
The Projector is not in focus Adjust the focus with the focus adjustment dial
until the image comes into focus
The Projector is offset from plane / angle of
operation
Move the projector so that it is both 180 degrees
and on an evern plane with the screen.
No Sync, No Signal
Troubleshooting
1. Be sure to setup the computer to enable a video signal output. On
some laptops this is done by pressing and holding Function F5 key. If
using the P4X as an external monitor on Windows based systems, this
can be done by selecting “extend my desktop to this monitor”. The P4X
projector accepts up to 1280x800 resolution. Depending on the video
driver different resolutions may need to be selected for proper output.