AAXA Technologies P2Jr - Manual (Page 7)

Getting Started
1. Connect the power cord to the P2jr.
2. Connect the wall plug into the wall power source.
3. Press the POWER button and hold for 2-3 seconds to switch on or switch
off the power
• The LED turns red while charging.
• The LED turns green when charging is finished.
• 4 hours of charge time is required to reach a full charge.
5
Powering ON the projector
Chapter 2
Powering OFF the projector
1. Press and hold the power button for 3 seconds.
2. The optical engine should power off and the fan should stop spinning.
Note: The P2jr Projector battery does not charge when it is in operation.