FRIGIDAIRE FRA064VU1 - Manual (Page 2)

How to Install
2
Installation
About 1 / 4 "
1. To prevent vibration and noise, make sure the unit is installed
securely and firmly.
CAUTION: All side louvers of the cabinet must remain exposed to
the outside of the structure.
2. Install the unit a little slanted so the back is slightly lower than the
front (about 1/4"). This will force condensed water to flow to the
outside.
How to install the unit
Place unit on floor, a bench or a table. There is a Left and Right side Filler Panels - be sure to use the proper
panel for each side. When installed, the flange for securing the panel in place to the window sill will be facing
into the room.
A. Hold the side panel in one hand and gently pull back the center to free the open end. See FIG. 1.
B. Slide the free end “ I” section of the panel into the cabinet as shown in FIG. 2. Slide the panel down. Be sure to
leave enough space to slip the top and bottom of the frame into the rails on the cabinet.
Left + Right Filler Panel Assembly
FIG.1 FIG.3
C. Once the panel has been installed on the side of the cabinet, make sure it sits securely inside the frame channel by
making slight adjustments. Slide the top and bottom ends of the frame into the top and bottom rails of the cabinet, see FIG.3.
D. Slide the panel all the way in and repeat on the other side.
FIG.2
“I” section
Install
Your air conditioner is designed to install in standard double
hung windows with opening widths of 26.5 to 41.5 inches
(673 mm to 1054 mm) (FIG. 4)
．
Lower sash must open sufficiently to allow a clear vertical
opening of 12.4 inches (315 mm ). Side louvers and the rear
of the air conditioner must have clear air space to allow
enough airflow through the condenser, for heat removal.
The rear of the unit must be outdoors, not inside a building
or garage.
Bottom Rail
Top Rail
Fig. 4
12.4 min
315 mm
Wooden Windows
INNER
WINDOW SILL
INTERIOR
WALL
26.5
673 mm to 1054mm
41.5