FRIGIDAIRE FPDF4085KF - Manual (Page 30)

30
Door Hinge locations
with oven door fully open
Figure 1
Figure 2
care and cleaning of stainless steel
Some models are equipped with stainless steel exterior
parts. Special care and cleaning are required for
maintaining the appearance of stainless parts. Refer
to the general care & cleaning table for detailed
cleaning instructions.
care & cleaning
Figure 3 Figure 4
Oven door
Around
Hinge
Special door care instructions -
Most oven
doors contain glass that can break.
Read the following recommendations:
1. Do not close the oven door until all the oven racks are
fully in place.
2. Do not hit the glass with pots, pans, or any other ob-
ject.
3. Scratching, hitting, jarring or stressing the glass may
weaken its structure causing an increased risk of
breakage at a later time.
caution
The door is heavy. For safe, temporary storage, lay the
door flat with the inside of the door facing down.
caution
The door is heavy. After removing door, lay it flat on
the floor with its inside facing down.
Removing and replacing the main oven
door (If equipped with hinge style A)
To Remove Oven Door:
1. Open oven door completely (horizontal with floor -
See Figure 1).
2. Pull the door hinge locks on both left and right
door hinges down from the oven frame completely
towards the oven door (See Figure 2). A tool such as
a small flat-blade screwdriver may be required.
3. Firmly grasp both sides of oven door along the door
sides (Do not use the oven door handle - See Figure 3).
4. Close the door to the broil stop position (the oven door
will stop into this position just before fully closing).
5. With the oven door in the broil stop position, lift the
oven door hinge arms over the roller pins located on
each side of the oven frame (See Figure 4).
To Replace Oven Door:
1. Firmly grasp both sides of oven door along the door
sides (Do not use the oven door handle - See Figure 3).
2. Holding the oven door at the same angle as the
removal position, seat the hook of the hinge arm over
the roller pins located on each side of the oven door
frame (See Figure 4). The hook of the hinge arms
must be fully seated onto the roller pins.
3. Fully open the oven door (horizontal with floor - See
Figure 1).
4. Push the door hinge locks up towards and into the
oven frame on both left and right oven door hinges
(See Figure 2) to the locked position.
5. Close the oven door.
Removing and Replacing the main oven
door (If equipped with hinge style B)
1. Open the door to the fully opened position.
2. Pull up the lock located on both hinge supports and
engage it in the hinge levers. You may have to apply
a little downward pressure on the door to pull the
locks fully over the hooks.
3. Grab the door by the sides, pull the bottom of the
door up and toward you to disengage the hinge
supports. Keep pulling the bottom of the door toward
you while rotating the top of the door toward the
range to completely disengage the hinge levers.
4. To replace the door, reverse the door removal steps.
Make sure the hinge supports are fully engaged
before unlocking the hinge levers.
Lock in normal
position
Lock engaged
for door removal
Hinge slot door removed
from the range