FRIGIDAIRE FGGS3045KF - Manual (Page 2)

2
30" GAS SLIDE-IN RANGE INSTALLATION INSTRUCTIONS
NOTE:
1. Do not pinch the power supply cord or the
flexible gas conduit between the range and
the wall.
2. Do not seal the range to the side cabinets.
3. 24" (61 cm) minimum clearance between
the cooktop and the bottom of the
cabinet when the bottom of wood or
metal cabinet is protected by not less than
¼" (0.64 cm) flame retardant millboard
covered with not less than No. 28 MSG
sheet metal, 0.015"(0.4 mm) stainless
steel, 0.024"(0.6 mm) aluminum, or
0.020" (0.5 mm) copper.
30" (76.2 cm) minimum clearance when
the cabinet is unprotected.
4. For cutouts below 22 7/8"(58.1 cm),
appliance will slightly show out of the
cabinet.
5. Allow at least 19 ¼" (48.9 cm) clearance
for door depth when it is open.
21¾”
(55.25 cm) D
C
A
B
Door Open
Side Panel
1 1/8"
(2.86 cm)
FRONT OF
CABINET
F
Ref.
22 7/8"(58.1 cm) min.
23 1/4"(59.05 cm) max.
(see Note 4)
*** IMPORTANT: To avoid cooktop breakage for cutout width (E dimension) of more
than 30 1/16" (76,4 cm), make sure the appliance is centered in the counter opening
while pushing into it. Raise leveling legs at a higher position than the cabinet height
(see page 3), insert the appliance in the counter and then level.
Make sure the unit
is supported by the leveling legs and NOT by the cooktop itself.
IMPORTANT: Cabinet and countertop width
should match the cutout width.
E
E
A. HEIGHT
(Under Cooktop)
B. WIDTH C. COOKTOP
WIDTH
D. TOTAL DEPTH TO
FRONT OF RANGE
E. CUTOUT WIDTH***
(Countertop
and cabinet)
F. CUTOUT
DEPTH
G. HEIGHT
OF COUNTERTOP
35 7/8" (91,1 cm)
36 5/8" (93 cm)
30" (76,2 cm) 31 1/2"
(80 cm)
28 5/16" (71,9 cm) 30±1/16"
(76,2±0,15 cm)
21 3/4" (55,2 cm) Min.
22 1/8" (56,2 cm) Max
24" (61 cm) Min. with
backguard
35 7/8" (91,1 cm) Min.
36 5/8" (93 cm) Max.