FRIGIDAIRE FGEF304DKB - Manual (Page 14)

14
BEFORE SETTING OVEN CONTROLS
CAUTION
REMOVE ALL OVEN RACKS and parts before
starting a self-clean cycle. If the oven racks are left
in the oven during the self-clean cycle, the glide ability
of the Effortless Oven Rack system will be damaged
and will cause all oven racks to loose their shiny
fi nish and or turn blue. Remove ALL oven racks and
clean according to instructions provided in the Care &
Cleaning section of this manual.
Make sure the oven and oven racks are COMPLETELY
cooled and safe to touch before attempting to assemble
or disassemble the Effortless™ Oven Rack system.
Never pick up hot oven rack parts.
The Effortless™ oven rack system
Some models are equipped with a special oven rack
system that automatically partially extends the oven rack
from the interior oven glides to assist in easier access to
your food items. This feature works whenever the oven
door is opened or closed.
To assemble the Effortless™ Oven Rack system:
1. Locate all required parts. You will need the supplied
oven rack (Effortless™ Oven Rack is a fl at rack with a
special dark coating on the left and right rack sides)
and the 2 supplied chrome connector arms.
2. Open the oven door. Be sure the oven is completely
cool before proceeding.
3. Place the oven rack in positions 1, 2 or 3 only (see
previous page to verify positions). Be sure the rack
connector brackets are at the rear of the range and
pointing towards oven bottom (See Figure 2).
4. Assemble one connector arm at a time. With the oven
door open and the oven rack in place, install one end
of the connector arm to the hole in the door connec-
tor bracket (Figure 1) and the other end in the hole
in the rack connector bracket (Figure 2 and as in
Figure 3). The oven rack may need to be adjusted in
or out in the rack position to match the length of the
connector arm.
5. While holding the connector arm in place, twist the
connector arm so the ends of the connector arm
point upwards (See Figures 4 & 5). The connector
arm should now be locked into position.
6. Repeat steps 4 and 5 for the other connector arm.
7. Once both connector arms are properly in place, be
sure to test the oven rack operation by gently closing
the oven door. The oven rack should move in and out
of the oven freely when the door is opened or closed.
Door
connector
bracket
Rack
connector
bracket
Oven rack Connector arm
Connector arm
Open oven door
Connector arm
Connector arm
Left and right
door connector
brackets with
connector arm ends
shown in locked position
(pointing upwards)
Figure 1
Figure 2
Figure 3 - Assembly of the Effortless oven rack TM
Figure 4
Figure 5
Figure 6 - oven rack after assembly Effortless™
Door
connector
bracket
Rack
connector
bracket
Oven rack Connector arm
Connector arm
Open oven door
Connector arm
Connector arm
Left and right
door connector
brackets with
connector arm ends
shown in locked position
(pointing upwards)
Figure 1
Figure 2
Figure 3 - Assembly of the Effortless oven rack TM
Figure 4
Figure 5
Figure 6 - oven rack after assembly Effortless™