9oven controls – FRIGIDAIRE FGEW2765PB User Manual
Page 9
9
OVEN CONTROLS
Setting the Clock
The set clock control is used to set the clock. The clock may
be set for 12 or 24 hours display operation. The clock is
preset at the factory for 12 hour display. When the oven is
first plugged in, or when the power supply to the oven has
been interrupted, the timer in the display will flash.
To set the clock (example below for 1:30):
1.
Press set clock. CLO will appear in the display.
2.
Press 1 3 0 on the keypad to set the time of day to 1:30.
CLO
will stay in the display.
3.
Press start. CLO will disappear and the clock will start.
Setting 12 or 24 Hour Time of Day Display
1.
Press and hold set clock for 6 seconds. CLO will
appear in the display.
2.
Continue holding the key until 12Hr dAY or 24Hr dAY
appears in the display and the control beeps once.
3.
Press self clean to switch between the 12 and 24 hour
time of day display. The display will show either 12Hr
dAY
or 24Hr dAY.
4.
Press start to accept the change or press off to reject
the change.
5.
Reset the correct time as described in this section. If the
24 hour time of day mode was chosen, the clock will
display time from 0:00 through 23:59 hours.
Table 1:
Minimum and maximum control settings
Feature
Mode
Minimum Temp. /Time
Maximum Temp. /Time
Preheat
170°F (77°C)
550°F (288°C)
Bake
170°F (77°C)
550°F (288°C)
Broil
400°F (205°C)
550°F (288°C)
Convection Bake
170°F (77°C)
550°F (288°C)
Convection Roast
170°F (77°C)
550°F (288°C)
Convection Broil
400°F (205°C)
550°F (288°C)
Slow Cook
Lo 225°F (108°C)
Hi 275°F (135°C)
Meat Probe
Lo 140°F (60°C)
Hi 210°F (99°C)
Timer
12 Hr. Mode
24 Hr. Mode
0:01 Min.
0:01 Min
11:59 Hr./Min.
11:59 Hr./Min.
Clock Time
12 Hr. Mode
24 Hr. Mode
1:00 Hr./Min.
0:00 Min
12:59 Hr./Min.
23:59 Hr./Min.
Delay Start
12 Hr. Mode
24 Hr. Mode
1:00 Hr./Min.
0:00 Min
12:59 Hr./Min.
23:59 Hr./Min
Bake Time
12 Hr. Mode
24 Hr. Mode
0:01 Min
0:01 Min
5:59 Hr./Min.
5:59 Hr./Min.
Self Clean Time
2 hours
4 hours
The features listed show the minimum and maximum time or temperature settings allowable.