FRIGIDAIRE FFSC2323LE - Manual (Page 8)

8
To remove the freezer top hinge cover:
1 Remove the two screws from each cover
over the top door hinges.
2 Lift hinge cover straight up and off.
Front
Cover Screws
Rear
Cover
Screw
Top Hinge
Cover
Hinge
Screws
Multi-Wire
Cable
Top
Hinge
To remove the freezer door:
1 Detach the multi-wire cable connector
located above the top hinge. Grasp both
sides of the connector firmly and pull apart.
Door
Hinge
Assembly Screws
Water
Line
Tubing
Non-Adjusting Hinge (some models)
Closer
Pin
Hinge
Door
Water
Line
Tubing
Screws
Hinge
Assembly
Adjustable Hinge (some models)
2 Trace lightly around the hinge with a
pencil. This makes reinstallation easier.
3 Detach the water tube from the connector
located below the freezer door. The
connector releases when you press its
outer sleeve inward.
4 Remove the screws from the top hinge
and pull the multi-wire cable through it.
Lift the door off of the bottom hinge.
5 Remove the two bottom hinge screws and
hinge if necessary.
DOOR REMOVAL INSTRUCTIONS
Adjustable Hinge (some models)
Door
Hinge
Assembly
Closer
Pin
Hinge Screws
3 Remove the two bottom hinge screws and
hinge if necessary.
CAUTION
Be sure doors are set aside in a secure position
where they cannot fall and cause personal injury.
To reinstall the refrigerator door, reverse the
above steps.
To Disconnect
1. Press outer ring against face
of fitting
2. Pull to
remove tube
To Connect
Insert tube and
push until mark touches face of fitting
6 Lay the door on its side to avoid damage
to the water tube extending from the
bottom hinge.
To reinstall the freezer door, reverse the above steps.