beautypg.com

Cub Cadet SERIES 5000 5252 User Manual

Page 42

background image

42

SERVICING THE PAPER ELEMENT

Replace the paper air cleaner element after every
100 hours of operation. Replace the element more
often if operating the tractor under extremely dusty
conditions. Refer to Figure 51.

Loosen the cover retaining knob and lift off the
air cleaner cover.

Remove the wing nut and lift off the element
cover. Lift out the paper air cleaner element
with precleaner.

Remove the foam precleaner by carefully
slipping it off the paper element.

Check the paper element for excessive dirt,
paper tears, or damage to the seal on the bot-
tom of the element. Replace a dirty or damaged
paper element. Do not use pressurized air to
clean the paper element.

When servicing the air cleaner, also inspect the
air cleaner base and the rubber seal for any
type of damage. Replace if damaged.

Slip the precleaner fully onto the paper ele-
ment and reinstall the paper element onto the
air cleaner base.

Install the element cover and secure with the
wing nut.

Reinstall the air cleaner cover and secure with
the retainer knob.

IMPORTANT:

Properly cleaned and installed

air cleaner elements significantly contribute to
prolonging engine life.

SERVICING THE SPARK PLUGS

WARNING: To avoid possible injury, be
sure the engine is off and has cooled
before making any adjustments or
repairs.

Check the spark plugs after every 100 hours of
operation. Replace with new plugs if necessary.
See your authorized dealer for the correct
replacement spark plugs (Pt. No. 759-3336).

Disconnect the spark plug wires and remove all
dirt from around the spark plug before
removing.

Use a spark plug wrench to remove spark plugs.

Clean carbon deposits from the electrodes
using a soft wire brush.

Inspect for cracked porcelain or any other wear
or damage. Replace with a new spark plug if
necessary.

Check the gap of the spark plugs. The gap
must be .030 inch (0.76mm). Reset if
necessary.

Figure 52

Reinstall the spark plugs and torque to 18 ft-
lbs. Connect the spark plug wires.

CHANGING THE FUEL FILTER

WARNING: Do not replace the fuel filter
when tractor is hot. Allow the tractor to
cool before separating the fuel lines.

The tractor is equipped with an in-line fuel filter. The
fuel filter can be accessed from underneath the
tractor along the left side of the tractor frame, just
forward of the fuel tank.

The fuel filter cannot be disassembled. Conse-
quently you must visually inspect the filter
periodically. Inspect for a build-up of residue inside
the filter body, and for a dirty element which can be
indicated by discoloration. Replace the fuel filter
when dirty.

.030 in. gap

This manual is related to the following products: