Combi 7040 Series - Manual (Page 4)

- 4 -
To lock brakes, push all brake levers down. Brake
levers are located on the back wheels only.
To unlock brakes, lift all brake levers up.
CAUTION
Push the stroller forward to ensure that the
brakes are properly engaged.
CAUTION
Be careful when reclining the backrest while
baby is in the stroller to prevent abrupt
changes in seating position.
Using the Guardrail
Using the Brakes
1. Squeeze both
buttons on the
underside of
the middle sec-
tion and lift up.
To lock swivels, make sure the lock lever is behind
the stroller frame; then lift all lock levers up.
To unlock swivels, push all swivel lock levers down.
1. Press release
button on the
underside of
the center sec-
tion of the
guardrail and
pull out.
2. Squeeze the
buttons on the
outside of the
stroller and lift
up to remove
one side of the
guardrail
2. Squeeze the
buttons on the
both outside
sections of the
stroller and
lift up to com-
pletely remove
the guardrail.
To remove individual sides
of the guardrail: To remove the
complete guardrail:
Note:
To rotate either
side of the
guardrail to
permit easy
access, release
center button
and swing the
guardrail out.
1. To place the backrest in the upright postion, press
in the tabs on both sides of the recline mecha-
nism and pull down on the cords while pushing the
recline mechanism toward the seat back.
2. To achieve a full recline, press in the tabs on both
sides of the recline mechanism and pull downward.
Adjusting the Reclining Backrest
Using the Swivel Wheels