Dodge 2015 Durango - Owner Manual User Manual

Page 57

2. The seat belt latch plate is above the back of the front

seat, and next to your arm in the rear seat (for vehicles

equipped with a rear seat). Grasp the latch plate and

pull out the seat belt. Slide the latch plate up the

webbing as far as necessary to allow the seat belt to go

around your lap.

3. When the seat belt is long enough to fit, insert the latch

plate into the buckle until you hear a “click.”

4. Position the lap belt so that it is snug and lies low

across your hips, below your abdomen. To remove

slack in the lap belt portion, pull up on the shoulder

belt. To loosen the lap belt if it is too tight, tilt the latch

Pulling Out The Latch Plate

Inserting Latch Plate Into Buckle

THINGS TO KNOW BEFORE STARTING YOUR VEHICLE 55