Power lumbar, Memory seat – Dodge 2015 Charger-SRT - User Guide User Manual
Page 31
Power Lumbar
• Push the switch forward to increase the
lumbar support. Push the switch rear-
ward to decrease the lumbar support.
• Pushing upward or downward on the
switch will raise and lower the position of
the support.
Memory Seat
The memory seat feature allows you to set
two different driver seating positions (ex-
cluding lumbar position), outside mirrors,
radio station preset settings and tilt/
telescoping steering column position (if
equipped). The memory seat buttons are
located on the driver's door panel.
To set a memory position:
1. Cycle the vehicles ignition to the ON
position.
2. Adjust all memory profile settings.
3. Press and release the S (SET) button.
4. Press and release the 1 or 2 button
within five seconds.
NOTE:
Before programming your RKE transmitters
you must select the feature through the
Uconnect
®
system. Refer to “Uconnect
®
Settings ” in “Understanding Your Instru-
ment Panel” in the Owner's Manual on the
DVD for further details.
To program a Key Fob to the memory position:
1. Cycle the vehicles ignition to the OFF position.
2. Select the desired memory profile 1 or 2.
3. Press and release the S (SET) button on the memory switch, then within five seconds
press and release the 1 or 2 button accordingly.
4. Press and release the LOCK button on the RKE transmitter within 10 seconds.
• To recall the saved positions, press 1 or 2 on the memory switch or press UNLOCK on
the programmed RKE transmitter.
Power Lumbar Switch
Driver’s Memory Buttons
G E T T I N G S T A R T E D
29