beautypg.com

Dodge 2015 Charger-SRT - User Guide User Manual

Page 149

background image

• To clear the vehicle's best 1/4 mile 400 meters) run, push and hold the

OK button for

two seconds.

Braking Distance

When selected, this screen displays the vehicle's braking distance, and the speed at which
the brake pedal was depressed.
• This feature will only function when applying the brakes at speeds above 30 mph

(48 km/h).

• Engaging the parking brake will disable this feature.
• The word “READY” will display when conditions are met for the event to begin.
• The distance and speed measurements display while the event is taking place.
• The distance measurement will be aborted if the brake pedal is released before the

vehicle comes to a complete stop.

• Pushing and holding the

OK button will clear the current and last run values.

Current G-Force

When selected, this screen displays the current G-Force (lateral and longitudinal) that
displays the directions of the forces.

Peak G-Force

When selected, this screen displays all four G-Force values (two lateral and two longitu-
dinal).
• When a force greater than zero is measured, the display will update the value as it

climbs. As the G-Force falls, the peak forces will continue to display.

• Push and hold the

OK button to clear the peak force values.

Lap Timer

When selected, the Lap Timer page will show the timer always at 0:00.00 with the
previous Best and Last time data (unless the driver has cleared it via hold to Reset).
• Pushing

OK will start “current” timer from 0:00.0.

• When

OK is pushed, the times are updated accordingly.

• As soon as the driver exits the Lap Timer pages, the “current” timer will stop and the

time will be reset to 0:00.00.

• If the driver stays on the Lap Timer pages, the “current” timer will reset to 0:00.0 when

ignition is placed in the off position, or ignition placed in the ON position (or will roll
over at 59:59.99 if ever possible).

• Each time the driver pushes

OK for a Lap that current time populates, the Last time and

also populates the 1st (top) space on the Timer History page the current time resets to
0:00.0 at every push of the

OK button.

• The timer will stop when the driver navigates away from this page.

E L E C T R O N I C S

147