Crosley Radio Performer CR2402A - Manual (Page 2)

13
Audio / Connections
Audio Connections
Aux Input
Using the Aux Input allows you to hook up additional
external audio components and listen to them through
your unit. Any component with an audio output such
as a Tuner, can be connected by using the correct
cables (not included). This unit uses standard RCA
cables. Simply plug the red and white connectors
on one end of the cable to the red and white Aux In
jacks on the back of your unit. The other end of the
cable will plug into the Audio Output jack on the
external component. For more information on hooking
up the external component, see the owner’s manual
for that component.
Audio Output
Using the Audio Output will allow you to run the
audio from your unit into a home stereo, television
or other stereo source. To make this connection,
you will need standard RCA cables. Plug the red
and white connectors on one end of the cable into
the red and white Audio Output jacks on the back
of the unit. The other end of the cable will plug into
the Aux Input jacks of your selected component. For
more information on hooking up to the external
component, see the owner’s manual for that
component.
NOTE: You can still listen to your unit when using the Audio
Output feature
Line In Jack
The Line In Jack is located on the front of your unit.
This jack uses a 3.5 mm mini pin cable for connection.
This connection is especially useful in hooking up
smaller audio components like MP3 players. To
make this connection, you will need a 3.5mm audio
cable (included). Hook one end of the cable into the
Line In Jack on the front of your unit. The other end
will plug into the Audio Output or headphone jack
on the selected component. For more information
on hooking up the external component, see the
owners manual for that component.
Audio Output
Aux Input
AUX IN
L
(WHITE JACK)
ANOTHER
AUDIO COMPONENT
L
R
AUDIO OUT
AUX IN
R
(RED JACK)
L R
AUDIO IN
AUDIO OUTPUT
R
(RED JACK)
AUDIO OUTPUT
L
(WHITE JACK)
The exclamation point
within an equilateral
triangle is intended to
alert user to the
presence of important
operating and
maintenance (servicing)
instruction in the
literature accompanying
the appliance.
RISK OF ELECTRIC SHOCK
DO NOT OPEN
CAUTION
The lighting flash with
arrowhead symbol, within
an equilateral triangle, is
intended to alert user to
the presence of uninsulated
"dangerous voltage" within
the product's enclosure
that may be of sufficient
magnitude to constitute
risk of electric shock
to persons.
CAUTION: TO REDUCE
THE RISK OF ELECTRIC
SHOCK, DO NOT REMOVE
COVER (OR BACK). NO
USER - SERVICEABLE
PARTS INSIDE. REFER
SERVICING TO QUALIFIED
SERVICE PERSONNEL.
Specification
Frequency Range : AM 530 - 1700 KHz
: FM 88 - 108 MHz
Power Supply : AC 120V ~ 60Hz
Power Consumption : 50W
Antennas
: External antenna for FM
: Built-in ferrite bar for AM
Speed : 33 1/3, 45, 78 RPM
Speaker : 3”x 5” 4ohm 5W x 2
Replacement Needle : NP4
WARNING:
TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS
APPLIANCE TO RAIN OR MOISTURE. DO NOT REMOVE COVER.
PILOT LAMPS SOLDERED IN PLACE. NO USER SERVICEABLE
PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE
PERSONNEL.
* DESIGN AND SPECIFICATIONS SUBJECT TO CHANGE WITHOUT NOTICE.