Ram Trucks uconnect 5.0 for Chrysler - Manual (Page 13)

Clock Setting
There are two ways to enter the clock setting procedure
on the Uconnect® 5.0 system.
1. Press the MORE hard-key on the right side of the
display, next press the “Time” soft-key and then press
the “Set” soft-key. OR Press the MORE hard-key on
the right side of the display. Next, press the “Settings”
soft-key, then “Clock and Date” soft-key, and then
“Set Time and Date” soft-key. Select the “Up” or
“Down” arrows as appropriate. Select “Done” when
complete.
NOTE: In the Clock Setting Menu you can also select
“Display Clock”. Display Clock turns the clock display
in the status bar on or off.
2. Touch the “Up” or “Down” arrows to adjust the hours
or minutes, next select the AM or PM soft-key. You can
also select 12hr or 24hr format by touching the desired
soft-key. Once the time is set press the “Done” soft-key
to exit the time screen.
12 RADIO MODE