Ram Trucks uconnect 5.0 for Chrysler - Manual (Page 12)

If the screen shows Acquiring Signal, you might have to
change the vehicle’s position in order to receive a signal.
In most cases, the satellite radio does not receive a signal
in underground parking garages or tunnels.
Audio
1. Press the SETTINGS hard-key on the right side of the
unit.
2. Then scroll down and press the “Audio” soft-key to
get to the Audio menu.
3. The Audio Menu shows the following options for you
to customize your audio settings”
• Equalizer — Touch the “Equalizer” soft-key to
adjust the Bass, Mid and Treble. Use the + or -
soft-key to adjust the equalizer to your desired
settings. Press the “Back Arrow” soft-key when
done.
• Balance/Fade — Touch the “Balance/Fade” soft-
key to adjust the sound from the speakers. Use
the “arrow” soft-key to adjust the sound level
from the front and rear or right and left side
speakers. Touch the Center
ЉCЉ soft-key to reset
the balance and fade to the factory setting. Press
the “Back Arrow” arrow soft-key when done.
• Speed Adjustable — Touch the “Speed Adjusted
Volume” soft-key to select between OFF, 1, 2 or
3. This will decrease the radio volume relative to
a decrease in vehicle speed. Press the “Back
Arrow” soft-key when done.
• Loudness — Touch the “Loudness” soft-key to
select the Loudness feature. When this feature is
activated it improves sound quality at lower
volumes.
2
RADIO MODE 11