beautypg.com

Reprogramming a single homelink® button, Using homelink, Security – Dodge 2014 Charger - Owner Manual User Manual

Page 291

background image

• If the indicator light stays on constantly, program-

ming is complete and the garage door/device should
activate when the HomeLink® button is pushed.

• To program the two remaining HomeLink® buttons,

repeat each step for each remaining button. DO NOT
erase the channels.

If you unplugged the garage door opener/device for
programming, plug it back in at this time.

Reprogramming A Single HomeLink® Button

To reprogram a channel that has been previously trained,
follow these steps:

1. Cycle the ignition to the ON/RUN position.

2. Push and hold the desired HomeLink® button until

the indicator light begins to flash after 20 seconds. Do
not release the button.

3. Without

releasing

the

button

proceed

with

“Canadian/Gate Operator Programming” step 2 and
follow all remaining steps.

Using HomeLink®

To

operate,

push

and

release

the

programmed

HomeLink® button. Activation will now occur for the
programmed device (i.e., garage door opener, gate opera-
tor, security system, entry door lock, home/office light-
ing, etc.,). The hand-held transmitter of the device may
also be used at any time.

Security

It is advised to erase all channels before you sell or turn
in your vehicle.

To do this, press and hold the two outside buttons for 20
seconds until the red indicator flashes. Note that all
channels will be erased. Individual channels cannot be
erased.

3

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

289