Dodge 2013 Journey - User Guide - Manual (Page 18)

• Lift the seat cushion up and push back to lock it in the booster seat position.
• Place the child upright in the seat with
their back firmly against the seatback.
• Grasp the latch plate and pull out the
seat belt.
• Slide the latch plate up the webbing as
far as necessary to allow the seat belt
to go around the child’s lap.
NOTE:
The lap portion of the seat belt should be low
on the hips and as snug as possible.
• Once the seat belt is long enough to fit
properly, insert the latch plate into the
buckle until you hear a “click.”
• To remove the slack from the lap belt, pull upward on the shoulder portion of the seat belt.
Installing The LATCH - Compatible Child Restraint System
• Your vehicle’s second row passenger seats are equipped with the child restraint anchor-
age system called LATCH, which stands for Lower Anchors and Tether for CHildren.
• All three second-row passenger seating positions have lower anchors that are capable
of accommodating LATCH-compatible child seats.
• Rigid fixed lower attachments can only be used in the outboard seating positions.
Flexible lower attachments can be used in all seating positions.
• When installing a child seat in the center seating position use one lower anchorage from
the outboard seating position and the center seat dedicated lower anchorage. If two
child seats are installed in adjacent seating positions you must use the vehicle seat belt
in the center seating position.
• You should NEVER install LATCH-compatible child seats so that two seats share a
common lower anchorage.
Installing The Lower Attachments:
• The vehicle lower anchorages are round bars located at the rear of the seat cushion
where it meets the seatback.
• Loosen the child seat adjusters on the
lower straps and on the tether strap so
that you can more easily attach the hooks
or connectors to the vehicle anchors.
• Attach the lower hooks or connectors over
the top of the seatcover material.
• Tighten all three straps as you push the
child restraint rearward and downward
into the seat, removing slack in the straps
according to the child restraint manufac-
turer’s instructions.
GETTING STARTED
16