Universal garage door opener (homelink®), Before you begin programming homelink, Programming a rolling code – Dodge 2012 Journey - User Guide User Manual

Page 64: Electronics, Universal garage door opener (homelink

• Lights

• Phone / Bluetooth

• Doors & Locks

• SIRIUS Setup

• Heated Seats

UNIVERSAL GARAGE DOOR OPENER

(HomeLink

)

• HomeLink

replaces up to three hand-held transmitters that operate devices such

as garage door openers, motorized gates, lighting or home security systems. The
HomeLink

unit is powered by your vehicles 12 Volt battery.

• The HomeLink

buttons that are located in the overhead console or sunvisor

designate the three different HomeLink

channels.

• The HomeLink

indicator is located above the center button.

Before You Begin Programming HomeLink®

• Be sure that your vehicle is parked

outside of the garage before you begin
programming.

• For more efficient programming and

accurate transmission of the
radio-frequency signal it is
recommended that a new battery be
placed in the hand-held transmitter of
the device that is being programmed to
the HomeLink

system.

• Erase all channels before you begin programming. To erase the channels, place the

ignition switch into the ON/RUN position, then press and hold the two outside
HomeLink

buttons (I and III) for up 20 seconds or until the red indicator flashes.

NOTE:
• Erasing all channels should only be performed when programming HomeLink

for the

first time. Do not erase channels when programming additional buttons.

• If you have any problems, or require assistance, please call toll-free 1–800–355–

3515 or, on the Internet at www.HomeLink.com for information or assistance.

Programming A Rolling Code

• For programming Garage Door Openers that were manufactured after 1995. These

Garage Door Openers can be identified by the “LEARN” or “TRAIN” button located
where the hanging antenna is attached to the Garage Door Opener. It is NOT the
button that is normally used to open and close the door. The name and color of the
button may vary by manufacturer.

• Place the ignition switch into the ON/RUN position.

• Place the hand-held transmitter 1 to 3 in (3 to 8 cm) away from the HomeLink

button you wish to program while keeping the HomeLink

indicator light in view.

• Simultaneously press and hold both the HomeLink

button you want to program

and the hand-held transmitter button.

ELECTRONICS