Dodge 2012 Grand_Caravan - User Guide - Manual (Page 75)

PROGRAMMABLE FEATURES
Electronic Vehicle Information Center (EVIC)
• The EVIC can be used to program the following Personal Settings. Press and
release the MENU button until Personal Settings displays, then press the DOWN
button
to scroll through the settings. Press the SELECT button to change
the setting.
• Language • Rain Sensing Wipers
• Nav-Turn By Turn • Key-Off Power Delay
• Enable/Disable the Rear Park Assist
System
• Illuminated Approach
• Auto Unlock Doors • Flashers with Sliding Door
• Remote Unlock Sequence • Hill Start Assist (HSA)
• RKE Linked To Memory • Easy Exit Seat
• Remote Start Comfort Sys. • Tilt Mirror In Reverse
• Horn With Remote Lock • Blind Spot Alert
• Flash Lamps With Lock • Calibrate Compass
• Headlamp Off Delay • Compass Variance
• Headlamps with Wipers (Available
with Auto Headlights Only)
• Turn Menu Off
• Intermittent Wiper Option
Key Fob Programmable Features
• The following features may also be programmed by using the Key Fob transmitter
or the ignition switch and driver's door lock switch.
NOTE: Pressing the LOCK button while you are inside the vehicle will activate the
Vehicle Security Alarm. Opening a door with the Vehicle Security Alarm activated will
cause the alarm to sound. Press the UNLOCK button to deactivate the Vehicle Security
Alarm.
Unlock On First Press
• To unlock either the driver's side, or all doors, on the first press of the UNLOCK
button:
• Press and hold the LOCK button for at least 4 seconds, but no longer than
10 seconds. Then, press and hold the UNLOCK button while still holding the
LOCK button.
• Release both buttons at the same time.
Auto Unlock Doors On Exit
• To have all of the vehicle doors unlock when any door is opened:
• Enter your vehicle and close all the doors.
• Cycle the ignition switch between LOCK and ON and then back to LOCK four
times, ending up in the LOCK position (do not start the engine).
• Press the power door UNLOCK switch to unlock the doors. A single chime will
indicate that programming is complete.
ELECTRONICS
73