beautypg.com

Operating your vehicle, Engine break-in recommendations, Turn signal/wiper/washer/high beam lever – Dodge 2012 Grand_Caravan - User Guide User Manual

Page 25: Turn signal/lane change assist

background image

ENGINE BREAK-IN RECOMMENDATIONS

• A long break-in period is not required for the engine and drivetrain (transmission

and axle) in your vehicle.

• Drive moderately during the first 300 miles (500 km). After the initial 60 miles

(100 km), speeds up to 50 or 55 mph (80 or 90 km/h) are desirable.

• While cruising, brief full-throttle acceleration within the limits of local traffic laws

contributes to a good break-in. Wide-open throttle acceleration in low gear can be
detrimental and should be avoided.

• The engine oil installed in the engine at the factory is a high-quality energy

conserving type lubricant. Oil changes should be consistent with anticipated
climate conditions under which vehicle operations will occur. For the
recommended viscosity and quality grades, refer to “Maintaining Your Vehicle”.

NOTE: A new engine may consume some oil during its first few thousand miles
(kilometers) of operation. This should be considered a normal part of the break-in and
not interpreted as an indication of difficulty.

CAUTION!

Never use Non-Detergent Oil or Straight Mineral Oil in the engine or damage
may result.

TURN SIGNAL/WIPER/WASHER/HIGH BEAM

LEVER

Turn Signal/Lane Change Assist

• Tap the lever up or down once and the turn signal (right or left) will flash three

times and automatically turn off.

• Vehicles equipped with Blind Spot Monitoring will produce a visual alert and may

be programmed to produce an audible alert when signaling a lane change; refer to
your Owner’s Manual on the DVD for operation.

OPERATING YOUR VEHICLE

23