beautypg.com

Dodge 2012 Grand_Caravan - Owner Manual User Manual

Page 238

background image

3. Simultaneously press and hold both the Homelink

button you want to program and the hand-held transmit-
ter button.

4. Continue to hold both buttons and observe the indi-
cator light. The Homelink

௡ indicator will flash slowly

and then rapidly after Homelink

௡ has received the fre-

quency signal from the hand-held transmitter. Release
both buttons after the indicator light changes from slow
to rapid.

5. At the garage door opener motor (in the garage),
locate the “LEARN” or “TRAINING” button. This can
usually be found where the hanging antenna wire is
attached to the garage door opener/device motor. Firmly
press and release the “LEARN” or “TRAINING” button.
On some garage door openers/devices there may be a
light that blinks when the garage door opener/device is
in the LEARN/TRAIN mode.

NOTE:

You have 30 seconds in which to initiate the next

step after the LEARN button has been pressed.

6. Return to the vehicle and press the programmed
HomeLink

௡ button twice (holding the button for two

seconds each time). If the garage door opener/device
activates, programming is complete.

NOTE:

If the garage door opener/device does not

activate, press the button a third time (for two seconds) to
complete the training.

To program the remaining two HomeLink

௡ buttons,

repeat each step for each remaining button. DO NOT
erase the channels.

Reprogramming A Single HomeLink

Button

To reprogram a channel that has been previously trained,
follow these steps:

1. Turn the ignition switch to the ON/RUN position.

3

UNDERSTANDING THE FEATURES OF YOUR VEHICLE

235

This manual is related to the following products: