beautypg.com

Electronic throttle control (etc) light, Air bag warning light, Service awd system message – Dodge 2012 Charger_SRT - User Guide User Manual

Page 79: Sport mode, Oil change indicator, What to do in emergencies

background image

- Electronic Throttle Control (ETC) Light

• This light informs you of a problem with the Electronic Throttle Control (ETC)

system.

• If a problem is detected, the light will come on while the engine is running. Cycle

the ignition when the vehicle has completely stopped and the shift lever is placed
in the PARK position; the light should turn off.

• If the light remains lit with the engine running, your vehicle will usually be

drivable; however, see an authorized service center immediately. If the light is
flashing when the engine is running, immediate service is required and you may
experience reduced performance, an elevated/rough idle or engine stall and your
vehicle may require towing.

- Air Bag Warning Light

• If the light is not on during starting, stays on, or turns on while driving, have the

vehicle serviced by an authorized service center immediately.

SERVICE AWD SYSTEM Message

• If the SERVICE AWD SYSTEM warning message appears after engine start up, or

during driving, it means the AWD system is not functioning properly. We
recommend you do not operate the vehicle. Have the vehicle serviced immediately.

SPORT

Sport Mode

• This light will illuminate when the sport mode is selected. This mode provides

performance based tuning.

Oil Change Indicator

Message

• If an “oil change” message (shown as Oil Change Due) appears and a single chime

sounds, it is time for your next required oil change.

Resetting The Light After Servicing
Vehicles Equipped With Keyless Enter-N-Go

• Without pressing the brake pedal, push the ENGINE START/STOP button and cycle

the ignition to the ON/RUN position (Do not start the engine.)

• Fully depress the accelerator pedal, slowly, three times within 10 seconds.

• Without pressing the brake pedal, push the ENGINE START/STOP button once to

return the ignition to the OFF/LOCK position.

Vehicles Not Equipped With Keyless Enter-N-Go

• Turn the ignition switch to the ON/RUN position (Do not start the engine.)

• Fully depress the accelerator pedal, slowly, three times within 10 seconds.

• Turn the ignition switch to the OFF/LOCK position.

WHAT TO DO IN EMERGENCIES

77

This manual is related to the following products: