beautypg.com

Accel/decel, Resume, Cancel – Dodge 2012 Avenger - User Guide User Manual

Page 22: Operating your vehicle

background image

Set

• With the Speed Control on, push and release the SET – button to set a desired

speed.

Accel/Decel

• Once a speed is set, pushing the RES + button once or the SET – button once will

increase or decrease the set speed approximately 1 mph (2 km/h).

• Push and hold the RES + button to accelerate in 5mph (8 km/h) increments or

push and hold the SET – button to decelerate in 5mph (8 km/h) increments;
release the button to save the new set speed.

Resume

• To resume a previously selected set speed in memory, push the RES + button and

release.

Cancel

• Push the CANCEL button, or apply the brakes to cancel the set speed and

maintain the set speed memory.

• Push the ON/OFF button to turn the system off and erase the set speed memory.

WARNING!

• Leaving the Electronic Speed Control system on when not in use is

dangerous. You could accidentally set the system or cause it to go faster than
you want. You could lose control and have a collision. Always leave the
Electronic Speed Control system off when you are not using it.

• Electronic Speed Control can be dangerous where the system cannot

maintain a constant speed. Your vehicle could go too fast for the conditions,
and you could lose control. A collision could be the result. Do not use
Electronic Speed Control in heavy traffic or on roads that are winding, icy,
snow-covered or slippery.

OPERATING YOUR VEHICLE

20