beautypg.com

Jacking and tire changing instructions, What to do in emergencies – Dodge 2011 Journey - User Guide User Manual

Page 74

background image

Jacking And Tire Changing Instructions

• Remove the spare tire, jack and tools from the stored location.

• Loosen (but do not remove) the wheel lug nuts by turning them counterclockwise

one turn while the wheel is still on the ground.

• Assemble the jack and jacking tools. Connect the jack handle driver to the

extension, then to the lug wrench.

• Place the jack underneath the lift area that is closest to the flat tire. Turn the jack

screw clockwise to firmly engage the jack saddle with the lift area of the sill flange.

• Raise the vehicle by turning the jack

screw clockwise. Raise the vehicle only
until the tire just clears the surface
and enough clearance is obtained to
install the spare tire.

• Remove the lug nuts, wheel cover (if

equipped) and wheel.

• Position the spare wheel/tire on the

vehicle and install the lug nuts with
the cone-shaped end toward the wheel.
Do NOT attempt to install a center cap
or wheel cover on the compact spare.
Lightly tighten the lug nuts clockwise.
To avoid the risk of forcing the vehicle
off the jack, do not tighten the nuts
fully until the vehicle has been
lowered.

• Lower the vehicle by turning the jack

screw counterclockwise, and remove
the jack and wheel blocks.

• Finish tightening the lug nuts. Push

down on the wrench while tightening
for increased leverage. Alternate nuts
until each one has been tightened
twice. The correct wheel nut tightness
is 95 ft lbs (130 N•m). If in doubt
about the correct tightness, have them
checked with a torque wrench by your
authorized dealer or at a service
station.

• Place the deflated (flat) tire and compact spare tire cover assembly in the rear

cargo area. Do not stow the deflated tire in the spare tire location. Have the full-sized
tire repaired or replaced as soon as possible.

• To stow the winch cable and retainer, fit the assembled jack-handle over the winch

drive nut. Rotate the jack-handle assembly clockwise until you hear the winch
mechanism click three times.

• Secure the jack and tools in their proper locations.

WHAT TO DO IN EMERGENCIES

72